02

2024

-

03

The use, structure and working principle of jaw crusher

Author:


1Purpose of the machine

The jaw crusher is used to crush various ores or rocks of medium hardness, and the compressive strength of the crushed material does not exceed250Mpa, This machine is usually used for the role of primary crushing materials, such as cement plants, iron ore plants, quarrying plants and other first material crushing.

2.Working principle and structural features

Jaw crusher is mainly composed of frame, moving jaw, eccentric shaft, fixed jaw plate, side guard plate, toggle plate, adjusting seat, flywheel, pulley, tie rod spring, etc. The motor drives the pulley through the V-belt and the eccentric shaft to rotate, making the moving jaw complex swing. The ore added to the crushing chamber is crushed due to the swing of the moving jaw, which causes the ore to be crushed by extrusion splitting. The flywheel and pulley play the role of storing energy and releasing energy, and the rotation of the crusher tends to be balanced.

2.1Rack

The frame is welded by steel plates, the bearing seat and the frame are welded as a whole, and the bearing cover and the bearing seat are combined into the frame bearing hole.

2.2Moving jaw and eccentric shaft

The moving jaw is a cast steel part. The moving jaw is suspended on the eccentric shaft through the bearing. The bearing is a radial spherical roller bearing, which is shrunk on the eccentric shaft through hot fitting and can withstand high impact load.

2.3Jaw plate and side guard plate

The fixed jaw plate is fastened on the frame by trapezoidal pressing block and bolt, the movable jaw plate is fastened on the movable jaw by trapezoidal block and bolt, and the side guard plate is fixed on both sides of the frame by bolt.

2.4Elbow plate and elbow plate lining

The elbow plate is made of chilled cast iron. The contact surface between the elbow plate and the elbow plate lining has different radians and high hardness. It is linear rolling contact during operation. In order to prevent sliding friction during operation, lubricant must not be injected into this contact surface.

2.5Pull rod and spring

The pull rod is installed at the bottom of the movable jaw through one end of the cylindrical compression spring, and the other end is installed on the spring tray at the rear of the frame. After the installation of the pull rod spring, the movable jaw is pulled backward to support the toggle plate and prevent the toggle plate from falling off.

2.6Pulley and flywheel

The pulley and flywheel are cast iron parts, and after reasonable processing, the piece has a balance weight to balance the eccentric shaft and the inertia force of the moving jaw.

2.7Discharge port adjustment range

The discharge port adjustment device is mainly composed of an adjustment screw, an adjustment nut and an adjustment pad. The pad plays a role.

Adjust the size and positioning of the discharge port.

3.Lubrication of the machine

The lubrication parts of this machine are frame bearing and moving jaw bearing. The lubrication system is manual dry oil centralized lubrication device. This device mainly includes manual dry oil pump, oil separator, rubber pipe joint and joint body. Users can use the handle of manual dry oil pump to inject appropriate amount of lubrication energy into each bearing before each shift according to actual working conditions.

Jaw crusher,Jaw type fine breaking machine,EpiPo