02
2024
-
03
Application, structure and working principle of fine crushing jaw crusher
Author:
Application, structure and working principle of fine crushing jaw crusher
Purpose of 1. Machine
This machine is mainly suitable for small and medium-sized mines, building materials, road construction, silicate and chemical industry, the compressive strength of the crushed materials is not greater250MPa. The main specifications are:PEX-150X750,PEX-175x750,PEX-250x750,PEX-250x1000,PEX-250x1200,PEX-300x1300Wait.
2. working principle and structural characteristics
This machine is similar to medium and coarse jaw crusher,It is mainly composed of frame, movable jaw, eccentric shaft, fixed jaw plate, movable jaw plate, elbow plate, adjusting seat, and flying wheel.
The electric motor drives the eccentric shaft by means of a V-belt via a sheave.,Make the moving jaw move back and forth,So as to crush the materials entering the crushing cavity.The crushed material is discharged from the discharge port by its own weight.
The fixed tooth plate is fastened to the front wall of the frame by pressing bolts.,The movable jaw plate is pressed on the movable jaw by means of pressure iron..When the tooth plate is worn(Usually the lower end is more worn)Both can be inverted,Continue to use.
The toggle plate lifting support moving jaw,Make it run outside according to a certain motion trajectory.,When foreign matters that cannot be broken enter the crushing cavity and cause the load to increase sharply,Can play the role of insurance,That is, through its own fracture,Cut off load,Protect other parts from damage.
For adjusting seatTThe type bolts are suspended on the ear seats on both sides of the frame,There is a set of adjusting shims between the adjusting seat and the rear wall of the rack.
Open the adjusting seat with hydraulic topper or adjusting bolt,Change the thickness of the gasket group to adjust the width of the discharge port,The desired product particle size is thereby obtained.
Hydraulic topper except for adjustment,Can be removed,With random accessories,Roof,For auxiliary tools for assembling and disassembling parts. In the event of a failure of the hydraulic topper,Available mechanical adjustment device substitution.
The tension spring device is used to ensure the moving jaw of the jaw crusher,The toggle plate and the adjustment seat are tightly engaged with each other,Ensure the normal operation of the crusher.The spring pre-pressure should not be too large when the crusher is working.,As long as it can eliminate the impact noise between the moving jaw of the toggle plate and the adjusting seat.
The guard plate is to prevent feeding,It is set up for damage to the moving jaw caused by material collision.
Jaw crusher,Jaw crusher,EpiPo
Previous Page
Previous Page
WhatsApp |