29

2024

-

02

Raw material mill structure, working principle and main performance indicators

Author:


1.Raw material mill structure and working principle

This mill is suitable for closed-circuit grinding system equipped with cyclone separator (the system has the function of drying raw materials, and the moisture content of dried raw materials is allowed6%Below, the moisture content of the raw material <0.5%4) Raw materials with qualified particle size are fed into the separator from the top of the separator, and powder is selected while drying; raw materials that need to be further ground enter the mill for grinding from the discharge port of the main cylinder of the separator, and the ground materials are returned to the separator for powder selection by the hoist in the system through the air chute. Here, the raw materials are dried by the waste heat of the kiln tail and the heat from the hot blast stove, and the moisture of the raw materials is dried in the powder separator.30%About, and in the mill by the separator and raw material mill can dry raw material moisture.4%, and when heating the stove (720℃ hot air, plus kiln tail320C waste heat, so that the temperature of the hot air volume into the system.450℃) Drying moisture content6%Therefore, it is a hot air guided raw material drying mill.

The scrap supplied by the inlet slot of the feeding device flows into the cylinder through the conical bushing in the hollow shaft journal. A wear-resistant liner is installed around the inside of the cylinder, in which there is a grinding body. Due to the rotation of the cylinder, the crushed material is attached to the grinding body to run together, and at the same time, it is crushed and flows into the discharge port through the journal bushing in the hollow shaft of the outlet and discharged out of the machine.

The double-layer partition plate and the outlet grate plate in the cylinder have narrow and grate holes, and bucket-type lift blades respectively discharge the powder passing through the grate gap. Due to the rotation of the cylinder, the powder gradually moves backward until it is discharged out of the machine.

The cylinder passes through two hollow shafts at the entrance and exit, and is supported by two self-aligning main bearings by the foundation. The bearings are lubricated by forced circulation oil supply. A thin oil lubrication station consisting of a high-pressure pump and a low-pressure pump ensures the smooth start-up and normal operation of the mill, and reduces the movement resistance of the shaft cylinder due to the cooling contraction of the cylinder when the mill stops.

Mill drive, from the drive main motor through the reducer speed reduction, by the diaphragm coupling, the transmission shaft and then through the diaphragm coupling connected with the hollow shaft, drive the discharge device hollow shaft to rotate the cylinder.

2.main performance index

Grinding method:             dry closed circuit

Cylinder support mode:         Two self-aligning main bearing supports

Transmission mode:              Edge drive (center drive)

Setting place:             Indoor

Number of bins:                 Two warehouses

Cylinder revolution:              7.29r/min

Cylinder rotation direction:         Rotate clockwise as seen from mill outlet side to inlet side

Crushed material:           Limestone (calcium oxide content48~53%) (clay, iron slag)

Feeding particle size:              15mmThe following accounts80%Above.

                         max:25 mm

Water:6%The following

Number of finished products:              88umSieve residue15%The following

Recirculating ratio:                300%~400%

Filling quantity of grinding body:          95t

Cylinder liner:             The first warehouse silicon manganese steel flat dish boss liner

                       The second warehouse high carbon high chromium steel inclined liner

 

Raw material mill,Drying raw material mill,Ball Mill