Welcome to the official website of Chaoyang Liaoxi Heavy Machinery Manufacturing Co., Ltd!

Tel:

PRODUCTS

Products

Raw Material Vertical Mill

Key words:

ball mill

Classification:

Hotline:

Product introduction:

Raw material vertical roller mill is absorbing foreign advanced technology, research and design of a high efficiency and energy saving, set drying, grinding, grading as one of the grinding equipment, widely used in mining, metallurgy, building materials, electric power, chemical, refractory and other industries. It is suitable for grinding materials with hardness below grade 8 and fineness of finished products not higher than -400, especially for grinding of brittle materials, such as limestone, clinker, coal, gypsum, power plant desulfurization powder, slag, fly ash, coal gangue and lead, zinc and copper raw ore.

Raw material vertical mill has the following characteristics:

one Low production cost

1. Low carbon power saving: vertical roller mill is a bed powder mill, high energy utilization rate, low power consumption, and ball mill less than 30 ~ 50% power consumption.

2. Less metal wear: roller and disc are not in direct contact, roller sleeve and liner are made of special wear-resistant materials, long life, less metal wear.

2. Low construction investment cost

1. No need for workshop: vertical roller mill crushing, drying, grinding, grading, conveying as one, the system process is simple, can be arranged in the open air, no need for workshop.

2. Land saving: Vertical roller mill and ball mill system compared to the floor area saving 50%. The construction cost is reduced by 70%, and the total investment is close to the traditional grinding system.

Iii. Product characteristics

1. Easy operation: The equipment is programmable control, remote automatic control, easy to operate.

2. Long life of the roller bearing: the roller is set at 15°, the rear end cover extends to the outside of the mill, the thin oil is forced to lubricated, the bearing running space is not polluted by dust, and the bearing life is extended by 2 to 5 times.

3. Small vibration: center feeding, stable material layer, reduce vibration; The roller is equipped with a limiting device to prevent destructive and violent vibration.

4. Easy maintenance: With the maintenance cylinder, the roller can be turned out of the mill, and the roller sleeve can be replaced and the mill roll maintenance can be completed in a very short time.

5. Small nuisance: low noise due to no inter-metal collision; System under negative pressure operation, no dust, clean environment.

6. High efficiency of powder selection: The use of efficient cage type powder separator, adjust the fineness sensitive, high efficiency of powder selection.

7. Tire roller or cone roller: the tire roller sleeve is symmetrical, and can be used on the reverse side to extend the service life.

Technical parameters:

Product Name	Specifications	Design ability (t/h)	Main technical performance	Transmission part
				Motor		Reducer
				Model	Power (kw)	Model	Speed ratio
Raw Material Vertical Mill	φ3450mm	180	Disc diameter3450mm, Grinding roll pitch diameter2450mm, Width of grinding roller800mm, Disc speed 24.5r/min		1300
Raw Material Vertical Mill	φ3800mm	220	Disc diameter3800mm, Grinding roll pitch diameter1800mm, Width of grinding roller675mm, Disc speed 30r/min		2800
Raw Material Vertical Mill	φ4700mm	270-300	Disc diameter4700mm, Grinding roll pitch diameter2200mm, Width of grinding roller840mm, Disc speed 27.83r/min		3150

High fine ball mill

Slag Vertical Mill

辽西重型机械

Links:Chaoyang Yellow Pages | Chaoyang Enterprise Network

Website Construction: Power of Chinese Enterprises Jinzhou | SEO Tags